The oil filter element is the oil filter. Its function is to remove impurities such as dust, metal particles, carbon deposits and soot particles in the oil to protect the engine. During the working process of the engine, metal wear debris, dust, carbon deposits and colloidal deposits oxidized at high temperatures, water, etc. are continuously mixed into the lubricating oil. The role of the oil filter is to filter out these mechanical impurities and colloids to ensure the cleanliness of the lubricating oil and extend its service life. The oil filter should have strong filtering ability, small flow resistance and long service life.
It is best to replace the brake pads, and don't wait until you have run 60,000 kilometers before replacing them. The car can be a means of transportation or a weapon that can hurt people. Especially the brake equipment, as long as there is a slight fault, remember to replace it, otherwise, at a critical moment, the brake failure is super dangerous and cannot be controlled at all.
The function of the air filter element is to filter out particulate impurities in the air, and it is installed in the intake pipe, at the front end of the air flow meter. When the engine is working, it needs to inhale a large amount of outside air. The "inhalable particulate matter" in the air is filtered out by the air filter element, and then enters the cylinder (or air intake) to mix with fuel for combustion. If the air filter element does not perform its proper filtering function, larger particles in the air will enter the engine for combustion, which will cause various "faults" over time.
Oil filter, also known as oil grid. It is used to remove impurities such as dust, metal particles, carbon deposits and soot particles in the oil to protect the engine. Oil filters are divided into full-flow and split-flow. The full-flow filter is connected in series between the oil pump and the main oil passage, so it can filter all the lubricating oil entering the main oil passage.
The auto air filter is installed in front of the carburetor or intake pipe to filter out dust and sand particles in the air and ensure sufficient and clean air entering the cylinder.
When choosing motorcycle tyres, the specifications must not be wrong. Even if the tyre width is narrower, it can be used if the specifications are correct. Wouldn't this cause unnecessary economic losses. After confirming the correct specification, the width of the tyre should be considered. Xiaoxin believes that if the economy allows, try to buy a wider tire, because the contact surface between the wide tire and the ground is large, and the grip is better. It can transmit the driving force and braking force well, make the engine performance play well, and improve the driving stability, comfort and safety.
